Epson Stylus Photo RX700 Start Here Manual page 6

3
Click Install.
4 Read the license agreement, then click Agree.
Note: Enter your administrator name and password, if necessary.
5
Click Install at the EPSON Scan Installer screen to install the scanner
portion of your software.
6 When the software finishes installing, click Quit.
7
Follow the on-screen instructions to install additional software.
Note: Click Quit when each part finishes installing.
8
When installation is complete, you see the Additional Software screen.
Follow the instructions on the screen to install the software. When
done, click Exit.
9
Close any open screens, remove the CD-ROM, and restart your
Macintosh.
10
Plug the flat end of the USB cable into any available USB port on
your Macintosh.
Follow the instructions below to add the RX700 to the Print Center
(OS X 10.2.x) or Printer Setup Utility (OS X 10.3.x).
Selecting the RX700
1
Open the OS X Applications folder, then open the Utilities folder and
start Print Center or the Printer Setup Utility.
If you see this screen, click Add.
2
On the Printer List screen, click the Add button.
3
On the next screen, select EPSON
USB from the pull-down menu.
4 Click Stylus Photo RX700.
Note: If the RX700 doesn't
appear, make sure it is turned
on and securely connected to
your Macintosh.
5
Click the Add button. You see
the Stylus Photo RX700 in the
Printer List.
6
Quit Print Center or the Printer Setup Utility. Now you're ready to
copy, scan, and print. See the Basics book or your on-screen
Reference Guide for instructions.
continue