Other Instructions - Gree GDN100AM-A3EBA1A Owner's Manual

6
Continuous button
Press this button to set continuous dehumidify.
Note: The drain hose must be installed to use the CO mode. Otherwise,
unit will stop when the water bucket is full.
7
FILTER Button
Press this button to turn off the Filter Cleaning Indicator. (When the
dehumidifier has been operating for 250 hours, the Filter Cleaning Indicator
will light up to remind to clean the filter.)

Other Instructions

1. Alarm Warning
If the bucket is full or not locked into place for over 3 min, a buzzer will go off
for 10s to remind you to empty the bucket or put it back into the correct
place.
2. Auto Stop
When the bucket is full, removed or not placed correctly or the humidity is
5%lower than the set humidity, the unit will automatically stop.
3. Memory Function
If power is lost, all of the control settings are remembered. So when power
is restored, the unit will start back up in the settings it was in when the
power was lost.
4. Bucket full light
This indicates that the bucket is full, removed or not placed correctly.
5. Clean the Filter indicator light
When the dehumidifier has been operating for 250 hours, the Filter Cleaning
Indicator will up to remind user to clean the filter.
6. On light
This indicates that the dehumidifier is on/off. When the dehumidifier is on,
the On light can be turned off or on by pressing "Filter" and "+" together
for 3 seconds. The light blinks continuously to show the bucket is full,
removed or not placed correctly.
7