Table of Contents
Advertisement
Concern
Potential Cause
Opening/Closing Of Doors/Drawers
Door(s) will
•
not close.
•
•
•
•
Drawers are
•
difficult to
move.
•
Running of Refrigerator
Compressor
•
does not run.
•
•
•
Refrigerator
•
seems to
run too
much or
too long.
Digital Temperature Setting Display
Digital
•
temperature
displays an
error.
Door was closed too
hard, causing other door
to open slightly.
Refrigerator is not level.
It rocks on the floor
when moved slightly.
Refrigerator is touching
a wall or cabinet.
Food/packaging is
obstructing the door
from closing.
Flipper mullion on left
fresh food door is not in
the correct position.
Food is touching shelf
on top of drawer.
Track that drawers slide
on is dirty.
Refrigerator is in
defrost cycle.
Plug at electrical outlet
is disconnected.
House fuse blown or
tripped circuit breaker.
Power outage.
The variable speed
compressor is designed
to run 100% of the
time except during the
defrost cycle. At times
it will run faster, such as
after a defrost cycle.
Electronic control
system has detected a
performance problem.
TROUBLESHOOTING
Common Solution
•
Close both doors gently.
•
Ensure floor is level and solid,
and can adequately support the
refrigerator. Contact a carpenter to
correct a sagging or sloping floor.
•
Ensure floor is level and solid,
and can adequately support the
refrigerator. Contact a carpenter to
correct a sagging or sloping floor.
•
Make sure there is no food/
packaging blocking the doorway.
•
Ensure the flipper mullion is in the
correct position to allow the door
to close. (See "Flipper Mullion" in
INSTALLATION.)
•
Remove top layer of items in drawer.
•
Ensure drawer is properly installed
on track.
•
Clean drawer, rollers, and track. See
CARE & CLEANING.
•
This is normal for a fully automatic
defrost refrigerator. The defrost
cycle occurs periodically, lasting
about 30 minutes.
•
Ensure plug is tightly pushed
into outlet.
•
Check/replace fuse with a 15 amp
time-delay fuse. Reset circuit breaker.
•
Check house lights. Call local
electric company.
•
It is normal for the compressor to
run continuously except during
defrost mode.
•
Contact Electrolux Customer Care
for assistance with any errors or
codes flashing in the display by
calling 1-800-374-4432.
27
Hide quick links:
Advertisement
Table of Contents
