Door Handle Installation - Frigidaire FRFG1723AV Use & Care Manual

CAUTION
Wear gloves and safety goggles. Use extreme CAUTION when installing these handles.
Door Handle
Mounting Instructions
1. Remove handles from
carton and any other
protective packaging.
2. Position fresh food
handle end caps over
upper and lower pre-
installed shoulder bolts
(A) that are fastened
into door, ensuring the
holes for the set screws
are facing toward the
opposite door.
3. While holding handle
firmly against door,
fasten upper and lower
Allen set screws (B) with
supplied Allen wrench.
4. Repeat steps 2 and 3 to
install opposite handle.
Ensure the holes for the
set screws are facing
toward the first door.
5. Position freezer drawer
handle end caps over left
and right pre-installed
shoulder bolts (A) that
are fastened to the
door, ensuring the holes
for the set screws are
facing down.
6. While holding handle
firmly against door,
loosely tighten right
Allen set screw (B)
with supplied Allen
wrench until there is
no gap between handle
and door.
7. Still holding the handle
firmly to the door, firmly
tighten left Allen set
screw (B) with supplied
Allen wrench.
8. Return to the right Allen
set screw (B) and firmly
tighten with supplied
Allen wrench.

DOOR HANDLE INSTALLATION

Mounting Freezer Drawer Handle

NOTE
When tightening the Allen set screws, it is imper-
ative to apply force to the longer arm of the Allen
wrench supplied in the handle packaging.

NOTE
Tighten all set screws so the screw is below the surface
of the handle. Draw the handles tight to doors/drawer
with no gaps. Opening the opposite door while tight-
ening the Allen screw makes installation easier.
The door handle may loosen over time or if it was
installed improperly. If this happens, tighten the set
screws on the handles.
Mounting Refrigerator Handles
11