Install Software - Epson Stylus CX5200 Start Here Manual

7

Install Software

®
For Macintosh
Stylus CX. Follow the steps below to install software for Windows.
1
Make sure the Stylus CX is not connected to your computer,
then turn on your computer.
Note: If your Stylus CX is turned on and connected to your
computer, you may see several New Hardware Wizard screens.
Click Cancel for each of these screens and disconnect your
Stylus CX. You can't install your software that way.
2
Insert your Stylus CX CD-ROM in your CD-ROM or DVD drive.
The Software Installation screen opens automatically.
3
Click Install.
Note: If the install screen doesn't open automatically, do the following:
For Windows XP: click Start >
the EPSON CD-ROM icon.
For Windows 2000/Me/98: double-click
double-click the
4
When you see the license agreement, read it and click Agree.
Then follow the instructions on the screen to install the drivers.
5
When you see this screen telling you
to connect your Stylus CX, make sure
it is turned on, then remove the sticker
from the USB port.
6
Connect the
USB cable to any available USB port
on your computer.
7
Connect the
the USB cable to your Stylus CX USB port.
After you connect your Stylus CX, Windows displays several
messages as it detects your device. If you don't see the
messages, make sure your Stylus CX is turned on.
8
Continue following the instructions on the screen to install the rest of
your software.
Note: It will take several minutes to install the remaining software.
Don't cancel the installation.
installation instructions,
EPSON CD-ROM icon.
flat end of the
square end of
see the booklet that came with your
My Computer. Then double-click
My Computer. Then
®
Click Cancel
Click Install