Figure 10: Rear Panel Of Nielsen Audio Rohs Compliant Digital Sge With Time Decoder Option - Nielsen 1000-1161 Series Equipment Manual

Equipment Manual: Encoder 1000-1161
Document #: 1050-1475
Revision: F
If the time code source supplies bare wires for connections:
1. The ends of the connecting wires should be stripped bare before insertion into the push-tabs.
The recommended stripping length is 5mm.
2. If using the push-tab connections and the time code source is a differential source, insert one
of the signal inputs into the left push-tab and insert the opposite polarity signal into the right
push-tab. Connect the shield/common/ground wire to the center push-tab.
3. If the time code source is not a differential source, connect the ground/common input signal
to the center push-tab and connect the signal input to the left push-tab.
Rear Panel – Arbitron Analog Encoder w/ Time Decoder Option Installed
100 -240 VAC
( VALID DATA
LED )

Figure 10: Rear Panel of Nielsen Audio RoHS Compliant Digital SGE with Time Decoder Option

ONLY
BYPASS
USE
MONITOR
ONE
CLOCK
CODE IN
Expanded view of time decoder connection area
Negative
Ground Input
LEFT CENTER
Input
CLOCK
CODE IN
Positive
RIGHT
Input
( BNC Connector )
CONFIDENTIAL AND PROPRIETARY INFORMATION
Copyright © 2014 The Nielsen Company. All rights reserved.
32