Installation; Figure 3: Rear Panel Of Nielsen Audio Rohs Compliant Digital Sge (With Time Decoder Options Installed) - Nielsen 1000-1161 Series Equipment Manual

Equipment Manual: Encoder 1000-1161
Document #: 1050-1475
Revision: F

2. Installation

Follow these steps to add the SGE to your equipment chain. Throughout the installation process,
ensure that all plugs are firmly attached to their corresponding sockets.
1. Place the SGE into a 19" rack in an indoor climate controlled environment. Nielsen Audio
recommends allowing ½" of rack space above and below the Encoder to allow for adequate
ventilation and reduce the chances of overheating. DO NOT block or otherwise impede
airflow through the sides of the instrument.
2. Secure the SGE using screws in each of the four front panel corners.
3. Confirm that the Enable/Bypass push button on the front panel is in the 'out' position to put
the Encoder into bypass mode. (See Figure 1)
4. To use the balanced XLR connectors, slide the Select switch on the rear panel to XLR.
To use the unbalanced BNC connectors, slide the Select switch on the rear panel to BNC.
5. Balanced XLR inputs on the SGE are female; thus, the mating XLR cable is required to be
male. The gender for output connections is the reverse of input, as shown in Figure 3.
Figure 3: Rear Panel of Nielsen Audio RoHS Compliant Digital SGE
(with Time Decoder options installed)
Copyright © 2014 The Nielsen Company. All rights reserved.
CONFIDENTIAL AND PROPRIETARY INFORMATION
13