Table of Contents
Advertisement
Equipment Manual: Encoder 1000-1161
Document #: 1050-1475
Revision: F
3.6. Using the LCD Menu
The SGE displays status and error messages on the front panel LCD.
Whenever the Encoder displays a message and remains in encode mode, pushing the Step and
Enter buttons simultaneously will clear the LCD message.
When the Encoder is in enable mode and is operating normally, it displays a default message of
"Encoding:" and a station specific message (station information).
Whenever an error occurs, a message describing the problem appears on the LCD.
When the Encoder is in push-button bypass mode, it displays "Bypass Mode Encoder Disabled." At
this time pressing the front panel STEP button repeatedly will display the following series of status
messages:
1. Host firmware version and build number, displayed as "Host: V:XXXX B:XXXX"
2. DSP firmware version and build number, displayed as "DSP: V:XXXX B:XXXX"
3. FPGA firmware version and build number, displayed as "FPGA: V:XXXX B:XXXX"
4. Amps information, provided for Nielsen Audio internal use only.
5. Time board status message (e.g., "No Time Board Expected").
6. Two numbers displayed as "XXXXXXXXXX XXXXXX" The first number is provided for
Nielsen Audio internal use only. The second number is the Encoder serial number.
7. Internal temperature of the unit in degrees Celsius, displayed as "Temperature XX C"
8. Sample rate information.
9. Configuration information, for example: "ON Modes: STEREO OE W P NETTS" For
Nielsen Audio internal use only.
10. Alarm level information, for Nielsen Audio internal use only.
11. Alarm minutes information, for Nielsen Audio internal use only.
At any stage in the sequence of messages above, pressing the Enter button will cause the LCD to
redisplay the default bypass message, "Bypass Mode Encoder Disabled."
CONFIDENTIAL AND PROPRIETARY INFORMATION
Copyright © 2014 The Nielsen Company. All rights reserved.
23
Advertisement
Table of Contents
