Table of Contents
Advertisement
TRANSPORTING THE PLANTER
Preparation - All Models
Make sure the planter is connected according to the
procedures outlined. See Connecting the Planter to the
Tractor.
Raise the markers and install the lockup pins.
Raise the planter to the maximum height.
Observe all safety precautions.
Preparation - Folding Models
IMPORTANT: Before transporting planters with wings
folded, empty at least half of the seed and ALL
fertilizers, insecticides and herbicides from the
hoppers on the wing units.
In addition to the procedures under All Models, complete
the following:
If the frame lock down pins are installed, remove the pins
before attempting to raise the wings.
IMPORTANT: Wings must fold straight up (90 degrees)
to the frame and no further. If the wings fold
beyond vertical (90 degrees) position, or the
wings are not locked into place, the wing
cylinders and other planter components can be
damaged. If the wings are not vertical, loosen the
lockup bar U-bolts on the frame and adjust the
bar anchor accordingly. Tighten the U-bolts to
169 Nm (125 ft. lb) torque.
Observe all the safety precautions.
m
WARNING: To avoid injury or death, stand
clear of machine when wings are unfolded.
Mechanical or hydraulic failure can allow
wings to fall rapidly.
Safety Precautions
•
Use good judgment when transporting the tractor
implements on the highway. Maintain complete
control of the machines at all times.
•
Comply with state and local laws governing highway
safety and regulations when moving machinery.
•
Always make the necessary safety precautions prior
to transporting the planter on public roads. This
includes maintaining the SMV (Slow Moving Vehicle)
emblem and using adequate lighting or other safety
warnings after dark except when prohibited by law.
•
Limit towing speed to 25 km/h (15 mph).
•
Never permit persons on tractor or planter.
m
WARNING: Serious injury or death can
result from contact with electric lines. Use
care when moving or operating this
machine near electric lines to avoid
contact.
4283411M1
Field Operations and Adjustments
01-25
Advertisement
Table of Contents
