Table of Contents
Advertisement
Front Weights
Add enough front weights to keep the tractor front wheels
on the ground at all times. Refer to the tractor Operator
Manual for Weight information about mounted and
semi-mounted implements.
Rear Wheel Weights
Add weights as required to maintain stability when
planting on hillsides and when transporting the planter.
PLANTER PREPARATION
Lubrication
Lubricate the planter as described in the Lubrication and
Maintenance Section. Also, check the fluid level in the
PTO pump. Add fluid if required.
Bolt Torque
Make sure all bolts, nuts, and screws are tight and all
cotter pins are spread.
IMPORTANT: Tighten lift wheel bolts after first day of
operation and periodically thereafter.
Tire Inflation
See the Specifications Section for the correct tire
pressure.
Planter Hydraulic Drive Controls
NOTE: Controls are for optional hydraulic seed drive.
Mount the seed drive controller in a suitable cab location.
Connect the input leads to the battery terminals.
For convenience, mount implement switch on lever
controlling planter raise-lower hydraulic circuit.
NOTE: Controller does not have to be mounted level to
operate properly.
Route the battery harness to the controller. Route the
output wire harness to the rear of the tractor.
NOTE: All electrical controls must be installed on the
tractor by the dealer.
4283411M1
Field Operations and Adjustments
Seed Discs
Install the desired seed discs in all metering units.
Chains
Make sure all drive chains are installed with proper
tension, alignment, and lubrication.
Weights
Add optional weights as necessary, especially for no-till
operation. Weights can be installed on the frame or on the
lift assist wheel arms.
Seed and Transmissions
Determine the seed and chemical rates before going to
the field, if possible, and set the transmission or the seed
drive controller accordingly. Make a test run in a clear
area to verify initial settings.
NOTE: If the planter is equipped with chemical
attachment, rates will change when adjusting the
seed transmission.
Planter Monitor
Monitor and Hydraulic Drive Controls
(1)
Monitor Console
(2)
AGCO Console
(3)
Implement Switch
01-19
Advertisement
Table of Contents
