Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Lifetime Manuals
  4. Sports & Outdoors
  5. QUICK ADJUST II 1008
  6. Owner's manual with assembly instructions

Lifetime QUICK ADJUST II 1008 Owner's Manual With Assembly Instructions

Basketball system
Hide thumbs

Advertisement

Quick Links

Download this manual
1

Advertisement

loading
Need help?

Need help?

Do you have a question about the QUICK ADJUST II 1008 and is the answer not in the manual?

Questions and answers

Related Manuals for Lifetime QUICK ADJUST II 1008

Summary of Contents for Lifetime QUICK ADJUST II 1008

  • Page 2: Quick Adjust

    Maintaining your privacy is our long-standing policy at Lifetime. And you can rest assured that Lifetime will not sell or provide your personal data to other third parties, or allow them to use your personal data for their own purposes.

  • Page 3: Safety Instructions

    POLE SECTION IDENTIFICATION Identify the pole sections before beginning assembly. Failure to assemble the pole sections correctly may result in severe personal injury or property damage as described on Page Two. ONCE THE POLE SECTIONS HAVE BEEN SEATED, THEY CANNOT BE SEPARATED. Note: Tapers and flares are exaggerated in the illustrations.

  • Page 4: Parts List

    PARTS LIST Part # Description DD00200 502025J Inner Guard AM01500 Rim Support Channel FS05300 Height Sticker Main Hardware (HH02400B) Rim Hardware (1028024) Pole Joint Hardware (1005748) **A MINIMUM OF TWO ADULTS ARE REQUIRED FOR ASSEMBLY**...
  • Page 5 HARDWARE IS ACTUAL SIZE (Unless otherwise indicated) Tools And Materials Required For Assembly (Not Included) 13. Ladder 1. Adjustable Wrench 15. Water Supply bags) 9. Tape Measure Screwdriver 11. Pencil or Marker 7. Hammer or Mallet...
  • Page 6 Customer Service Department for Sleeve enables the pole to prices and freight: be cemented in, yet still removable. The sleeve sits LIFETIME PRODUCTS, INC. flush with the ground level P.O. BOX 160010 BLDG. D-11, FREEPORT CENTER diameter poles.
  • Page 7 The Ground Sleeve provides an from the dimpled end alternative to cementing the pole into of the Bottom Pole (BP) (do not the ground permanently. See Page 6 for more scratch the powder coating). information. diameter. The edge of the hole should be flush with the edge of the playing surface.
  • Page 8 Required For This Page: the Bottom Pole (BP). Rebar Check the pole several times in the first hour to make sure the sides are vertical and that the pole does not sink into playing surface. Allow 1-4 hours for the concrete to set. Do not continue until the concrete has set for 1-4 hours.
  • Page 9 Required For This Page: RJ (2) **Two Adults Required for this Step** Only finger tighten the Nuts (RG) now.
  • Page 10 Required For This Page: 7 1/8” (Not actual length) Bend the Backboard Brackets (LB & RB) out. Remove the plastic film from the Backboard. Screws (ML) through the top holes in the Backboard Brackets and into the Backboard. Do not overtighten the Screws. Completely tighten all Rim hardware.
  • Page 11 Required For This Page: 7 1/8” (Not actual length) 7” (Not actual length) Tighten the Nut until it is flush with the Bolt. Lift the Adjustment Mechanism and Outer Guard so the slots line up Tighten the Nut until it is flush with the Bolt. WARNING Do not operate the system without the plastic guards in place over the adjustment mechanism.
  • Page 12 Required For This Page: Screwdriver Align the small hole in the Top Pole with the slot in the Middle Pole and slide the Top Pole over the Middle Pole. Do not jam the poles together until instructed. Note: There are two screw holes at the bottom of the pole.
  • Page 13 Required For This Page: 7 1/8” (Not actual length) **2 Adults Required For This Step** The Backboard and Rim should be on the ground, resting on The Backboard should face the same way as the Warning Sticker. Tighten each Nut until it is flush with the Bolt. Attach the Net (AB).
  • Page 14 Required For This **2 Adults Required For This Step** Page: Screwdriver Make sure the Backboard faces the playing surface and Electric Drill align the small hole in the Middle Pole with the correct slot in the Bottom Pole. Slide the Middle Pole (MP) over the Bottom Pole PA (1) (BP).
  • Page 15 à l’anneau, au panneau ni aux leviers sous peine d’endommager l’équipement et d’annuler la garantie. www.lifetime.com #FS16500 10/12/2004 Operation of the height adjustment system TO RAISE: Place the end of a long object, such as a broom handle, under the goal and push up.
  • Page 16 CLAIMS IF PARTS ARE UNAVAILABLE OR OBSOLETE. 1. Lifetime basketball systems are warranted to the original purchaser to be free from defects in material or workmanship for a period of five years from the date of original retail purchase. The from misuse, abuse or negligence will void this warranty.