Advertisement
POLE SECTION IDENTIFICATION
Identify the pole sections before beginning assembly. Failure to assemble the
pole sections correctly may result in severe personal injury or property damage as
ONCE THE POLE SECTIONS HAVE BEEN SEATED, THEY CANNOT BE SEPARATED.
Note: Tapers and flares are exaggerated in the illustrations.
TP
Top Pole:
Four holes at the
top of the pole, two
small holes at the
bottom.
FAILURE TO FOLLOW THESE WARNINGS MAY RESULT IN SERIOUS INJURY OR PROPERTY DAMAGE AND WILL VOID
Owner must ensure that all players know and follow these rules for safe operation of the system.
To ensure safety, do not attempt to assemble this system without following the instructions carefully. Check
entire box and inside all packing material for parts and/or additional instruction material. Before beginning
assembly, read the instructions and identify parts using the hardware identifier and parts list in this document.
Proper and complete assembly, use and supervision are essential for proper orientation and to reduce the risk
of accident or injury. A high probability of serious injury exists if this system is not installed, maintained, and
operated properly.
any underground lines.
sections to separate during play or transport.
Most injuries are caused by misuse and/or not following instructions. Use caution when
described on Page Two.
MP
Middle Pole:
One slot at the top of
the pole, two small
holes at the bottom.
Warning
Sticker.
SAFETY INSTRUCTIONS
WARRANTY.
using this system.
BP
Bottom Pole: Two
slots at the top of
the pole, dimples
at the bottom.
3
Advertisement
