ADTRAN Total Access 850 Installation And Maintenance Manual page 9

Access 850), please contact ADTRAN at (256) 963-8000
for repair/warranty information. The telephone com-
pany may ask you to disconnect this equipment from
the network until the problem has been corrected or
until you are sure the equipment is not malfunctioning.
6. This unit contains no user-serviceable parts.
7. The following information may be required when
applying to your local telephone company for leased
line facilities.
For a T1/FT1 Port:
Service Type REN/
SOC
1.544 Mbps - SF 6.0N
1.544 Mbps - SF and 6.0N
B8ZS
1.544 Mbps - ESF 6.0N
1.544 Mbps - ESF 6.0N
and B8ZS
When connecting FT1 port towards the network, a
suitable crossover cable is required.
This equipment has been tested and found to comply
with the limits for a Class A digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference when the equipment is operated in a
commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction
manual, may cause harmful interference to radio
frequencies. Operation of this equipment in a
residential area is likely to cause harmful interference in
which case the user will be required to correct the
interference at his own expense.
64200376L1-5A
FIC USOC
04DU9-BN RJ-48C
04DU9-DN RJ-48C
04DU9-1KN RJ-48C
04DU9-1SN RJ-48C
NOTE
Shielded cables must be used with this unit to ensure
compliance with Class A FCC limits.
Change or modifications to this unit not expressly
approved by the party responsible for compliance
could void the user's authority to operate the
equipment.
Industry Canada Compliance Information
Notice: The Industry Canada label applied to the prod-
uct (identified by the Industry Canada logo or the "IC:"
in front of the certification/registration number) signi-
fies that the Industry Canada technical specifications
were met.
Notice: The Ringer Equivalence Number (REN) for this
terminal equipment is supplied in the documentation
or on the product labeling/markings. The REN
assigned to each terminal device indicates the
maximum number of terminals that can be connected to
a telephone interface. The termination on an interface
may consist of any combination of devices subject only
to the requirement that the sum of the RENs of all the
devices should not exceed five (5).
Canada Emissions Requirements
This digital apparatus does not exceed the Class A lim-
its for radio noise emissions from digital apparatus as
set out in the interference-causing equipment standard
entitled "Digital Apparatus," ICES-003 of the Depart-
ment of Communications.
Cet appareil numérique respecte les limites de bruits
radioelectriques applicables aux appareils numériques
de Class A prescrites dans la norme sur le materiel
brouilleur: "Appareils Numériques," NMB-003 edictee
par le ministre des Communications.
Canadian Class A Products
This Class A digital apparatus complies with Canadian
ICES-003.
Cet appareil numérique de la classe A est conforme á la
norme NMB-003 du Canada.
Issue 14, April 2003
WARNING
9