Charging The Battery; Power Connection; Charging The Battery Only; Battery Charging Time - Audiovox CDM-8500 Manual

CHARGING THE BA
CHARGING THE BA

POWER CONNECTION

Connect the charger to a standard 110V AC outlet. This
charger can charge the phone with the battery attached
or just the battery.

CHARGING THE BATTERY ONLY

To charge the battery only, insert the battery pack into
the charging slot on the charger.
The LED will indicate charging status.
-Red indicates charging is in progress.
-Green indicates charging is complete.
NOTE: 1. The battery is not charged at the time of
purchase.
2. Fully charge the battery before use.
Page 14 - Chapter 1
TTER Y CHARGING THE BA
TTER Y CHARGING THE BA
NOTE: 1. It is more efficient to charge the battery with
the handset off.
2. The battery must be connected to the phone in
order to charge it.
3. If the LED flickers while charging, the battery
contacts may need cleaning.
4. Once fully charged, the LED may change from
red to green. This does not indicate a problem
with the battery.
5. Battery operating time gradually decreases over
time.
6. If the battery fails to perform normally, you may
need to replace the battery.

BATTERY CHARGING TIME

Battery Type
Charging Time
NOTE: Charging time applies only when your phone is
turned off. Charging time may vary if your phone
is turned on.
BATTERY TALK & STANDBY TIMES
Status
Talk (min)
Standby (hrs)
NOTE: These times are for a new battery. Talk and
standby time may decrease over time.
TTER
TTER
BTR- BTE-
( mAh) ( mAh)
minutes minutes
Type
PCS CDMA AMPS
157 150
113 103
Chapter 1 - Page 15
Y
Y
103
25