Lex Configuration; Wpim-E1 Physical Configuration - Enterasys WPIM-E1 Network Manual

CHAPTER 2: LOCAL MANAGEMENT

2.6 LEX CONFIGURATION

This section provides step-by-step instructions for configuring the
WPIM-E1 to operate in a LEX environment. LEX (LAN Extender) is a
Cisco Systems protocol that allows a core router to communicate to a
remote site using PPP.
The line configuration information shown in Table 2-4 must be supplied
by the service provider.
Table 2-4. Telco Configuration Information
Configuration Information
Required by User
Line Coding
Frame Type
Clock Source
2.6.1 WPIM-E1 Physical Configuration
Begin the WPIM-E1 configuration by accessing the WAN Configuration
screen through Local Management (Figure 2-1). Access the WAN
Physical Configuration screen from the Feature Selection screen that first
appears when you enter Local Management. Use the arrow keys to
highlight the WAN Configuration option, then press ENTER. The screen
shown in Figure 2-1 appears. Proceed with the following steps:
1. Use the arrow keys to highlight the [WPIM] field at the bottom of the
screen. Press the SPACEBAR to select the WPIM being configured,
then press ENTER.
2. Use the arrow keys to highlight Timeslot View. Press the
SPACEBAR to select New, then press ENTER. The cursor moves to
Timeslot #2 of the Timeslot Configuration Table.
2-22
Configuration Information
Supplied by Service Provider
HDB3 or AMI
E1 or E1-CRC
Loop Timing or Local Timing
WPIM-E1 LOCAL MANAGEMENT GUIDE