Burner control unit
Burner control unit VUC 310
Status Service
Status Service
Information display / configuration display
The information display and the configuration display
are activated from the operating display. Press S for
more than 2 s to activate the menu selection. You can
scroll through the menu items with / . To select a
menu point press S again. The relevant point is then
indicated under Service.
If no other key is pressed within 20 s, this mode is
automatically terminated.
Information regarding current meter readings, such as
the start-up meter and permanent hours run meter, can
be called up via the information display.
Information:
Menu
Description
point
1
Permanent meters for start-ups and hours run
2
Resettable meters for start-ups and hours run
3
Software version
4
Fault history for the last 10 fault codes
Example: To clear the hours run meter, press the fol-
lowing keys:
1. S longer than 2 s, " " flashes.
2.
until "2" is shown under Service.
3. S "1" is displayed under Status.
22
(cont.)
Maintenance program, no
air pressure
Maintenance program, no
gas pressure or mains un-
dervoltage
Status Service
Status Service
4.
Scroll through Status until "6" is shown under
Status:
Sta-
Description
tus
1
Display of resettable start-up meter, 1
digit
2
Display of resettable start-up meter, 1000
digit
3
Menu point for deleting the start-up meter
reading
4
Display of resettable hours run meter, 1
digit
5
Display of resettable hours run meter,
1000 digit
6
Menu point for deleting the hours run me-
ter reading
5. S to confirm the deletion. If deleted successfully,
"1" is shown under Service; if it failed, "0" is
shown.
6. S to change to the operating display.
Menu points "5" and "6" are used to adjust configura-
tion settings of the burner control unit.
Note
Only make adjustments when the burner control unit is
on standby.
Configurations:
Menu
Description
point
5
Changeover from the operating display of the
burner control unit phase to other process in-
formation
6
Configuration of control function operating pa-
rameters
Forced ventilation if no
flame formation has been
detected.
Safety shutdown due to
loss of flame