Programming A Thermostat With A Network Programmer - Friedrich EMRT2 Instruction Manual

Before You Begin

Programming a Thermostat with a Network Programmer

In case of Network Installation with Online management, the thermostat must
be programmed with a Network Programmer specific to the property before the
installation.
The thermostat must not be powered during the pairing procedure.
Plug one programmer connector into the thermostat;
Push the black button on the programmer. The red light on the programmer
should turn on and remain steadily lit;
If the red light on the programmer is blinking or is not steadily lit, unplug the
programmer from the thermostat and repeat the steps above.
Unplug the programmer from the thermostat;
7