Thermostat Installation; Pairing The Thermostat And The Control Card - Friedrich EMWRT2 Instruction Manual

Before You Begin

Pairing the Thermostat and the Control Card

The Thermostat and Control Card must be paired in order to operate together.
Once paired, the thermostat cannot be used with another wireless control card
without repeating the pairing procedure. Friedrich thermostats are pre-linked with
the card in the box.
In case of Network Installation with Online management, the thermostat and the
Control Card must be paired with a Network Programmer specific to the property
before the installation.
The thermostat and Control Card must not be powered during the pairing
procedure - remove batteries from the thermostat and unplug the control card
from the
PTAC/ Vert-I-Pak unit during the pairing procedure.
Plug one programmer connector into the thermostat;
Plug the other programmer connector into the control card;
Push the black button on the programmer. The red light on the programmer
should turn on and remain steadily lit;
If the red light on the programmer is blinking or is not steadily lit, unplug the
programmer from the thermostat and the control card and repeat the steps
above.
Unplug the programmer from the thermostat and the control card;
8