Table of Contents
Advertisement
Place the shunts over the pins as required for your type of
computer. See Figure 2-8, below.
Figure 2-8. Setting Clock Source Jumper JP-1
2.7.2 Preparing the T3015 for Installation
The parameters for the T3015 adapter are set when the Adapter De-
scription File (ADF) is configured. The ADF file distinguishes the
adapter from other boards in the computer. The ADF will be config-
ured after the adapter is installed.
2.7.3 Installing the T3015 Adapter
To install the adapter in your computer, follow these instructions:
• Turn off the power to the PC and peripherals and disconnect
all power cords and cables.
• Following the instructions in your computer user manual,
using static discharge precautions, remove the cover from the
computer.
• Select the slot in which the adapter will be installed. Your
adapter can occupy any Micro-Channel style 16-bit expansion
slot. The T3015 adapter can also be used in the rearmost half of
a 32-bit Micro-Channel slot.
PS-2
Model 50
JP-1
INSTALLATION
PS-2
Models 70, 80
JP-1
Page 2 - 11
Advertisement
Table of Contents
