Cabletron Systems T2015 Installation Manual page 20

INSTALLATION
If you are not going to install a Boot PROM at this time, proceed to
Section 2.6, LANVIEW LEDs, for an explanation of the functions of
these diagnostic LEDs.
2.5 INSTALLING A BOOT PROM
The adapter incorporates a socket for an optional Boot PROM. The
Boot PROM plugs into the empty 32-pin socket shown in
Figure 2-5. By installing a Boot PROM, you can use the adapter to
boot up your PC, without a hard drive, onto a network running,
for example, the Novell® NetWare network operating system. The
Boot PROM address is linked to the I/O address as shown in Table
2-1 on page 2-5. Software installation instructions are included
with the Boot PROM.
2.5.1 Boot PROM and Socket Alignment
Observe all precautions when handling the Boot PROM.
!
Static discharges may damage the Boot PROM.
CAUTION:
To install a Boot PROM, remove the Boot PROM from its
packaging. Insert the Boot PROM into the PROM socket so that the
notched corner on the PROM is aligned with the notch on the
socket as shown in Figure 2-5. Note the dimple in the top center of
the PROM.
Page 2 - 8
Notched Corner
PROM Socket
Figure 2-5. Installing a Boot PROM
Dimple
Boot PROM