Panasonic Lamdash ES‑BST6Q Operating Instructions Manual page 18

Problem
The shaving sensor
responds even though the
shaver is not in contact
with the skin.
Foam cannot be made in
shaving foam mode.
ES-BST6Q
Foam made in shaving
foam mode contains
shavings. ES-BST6Q
The shaver cannot be
charged.
18
Action
Clean the beard trimmings from
the shaver.
When the shaver is extremely
dirty, remove the foil frame and
wash with water.
(See page 15.)
Replace the system outer foil and/
or inner blades.
Expected life of system outer foil
and inner blades:
System outer foil:
Approximately 1 year
Inner blades:
Approximately 2 years
Making foam may be difficult
depending on the type of facial
cleansers etc., so adjust the
amount of water or facial cleanser.
Before making foam, cleanly rinse
off any shavings. (See page 14.)
The recommended temperature
for charging is 10 °C – 35 °C. If
charged at a temperature other
than the recommended
temperature, the shaver may take
longer to charge or may not
charge at all.
Problem
Operating time is short
even after a full charge.
Shaver does not operate
even after charging.
The driving sound
changes while shaving.
Action
Although the shaver can be used
for about 2 weeks after a full
charge (assuming dry‑shave
usages for 3 minutes per day), the
usable number of days might be
lower depending on how or where
the shaver is used (for example,
when used for wet shaving).
Apply oil.
When the number of operations
per charge starts to decrease, the
battery is nearing the end of its life.
Use the appliance in an ambient
temperature approximately 5 °C
or higher.
The battery has reached the end
of its life.
The shaver will not operate with
the AC adaptor connected.
Please use the shaver after it has
been sufficiently charged and the
AC adaptor disconnected.
The shaving sensor is operating.
The sound changes depending on
the beard thickness.