Panasonic Lamdash ES‑BST6Q Operating Instructions Manual page 12

Making foam
ES-BST6Q
It is easier to make foam this way than by hand.
1
1
Take an appropriate amount of
facial cleanser etc� in the palm
of your hand�
2
2
Add an appropriate amount of
water or hot water�
3
3
Hold the power switch for
2 seconds or more to switch to
shaving foam mode�
The switch lock lamp (
and charge status lamp (
blink alternately.
• The shaving foam mode ends after 15 seconds. The shaver
can then be used to shave.
• To stop using the shaving foam mode and start shaving,
press the power switch once.
12
)
)
• When the switch lock lamp (
pressed, the shaver will not operate as it is locked. Press the
power switch for more than 2 seconds to unlock. (See page 14.)
4
4
Press the blades gently in the
palm of your hand, mix the
facial cleanser etc� around and
move the blades up and down
to make foam.
• If there is insufficient foam, add slightly
more water, hot water or facial cleanser
etc. to make it easier to create foam.
► Notes
• Before making foam, check that the blades are not broken or
deformed, and that the cleaning shutter is closed.
• Do not use shaving agent (excluding foam), facial cleansing
foam (with scrubbing compounds) or soap as these may cause
the blades to clog, or be unable to make foam.
Shaving
1
1
Press and shave�
• The power cannot be turned on when the
switch lock lamp ( ) blinks, as the
power switch is locked.
Press the power switch for more than
2 seconds to unlock. (See page 14.)
) blinks after the power switch is