Welbilt Frymaster FilterQuick easyTouch FQG120T Service Manual page 46

6. When the update has completed on ALL screens, press the YES button to confirm.
7. Remove the USB from the fryer.
8. Slide the USB cover down to cover the port.
Push and hold the black toggle switch from step 3 for
To update other vat menus, continue to Step 8, otherwise skip to Step 9.
Step 8 – Manually Update the Menus on the other vats
1. On the left screen, press
2. Insert the USB into the USB port.
3. Configurations –
a. Most configurations are Standard Left.
The menus are from left to right - Left 3 Battery fryer: Vat 1-Seafood, Vat 2- Fries, Vat 3- Spicy Right 3 Battery
fryer: Vat 1(4) - Spicy, Vat 2 (5) – Mild, Vat 3 (6) – Mild
b. Some configurations are a Mirror Configuration
The menus are from left to right - Left 3 Battery fryer: Vat 1- Mild, Vat 2- Mild, Vat 3- Spicy Right 3 Battery
fryer: Vat 1(4) - Spicy, Vat 2 (5) – Fries, Vat 3 (6) – Seafood
4. Follow onscreen instructions. Each menu file must be loaded individually to the appropriate vats by selecting the correct
vat when prompted to SELECT THE VATS FOR MENU UPGRADE. Select ONLY the vats to be updated. Only Mild will be
loaded to two vats at a time, by choosing 2 and 3 for Standard Left configurations or 1 and 2 for Mirror Configuration,
when prompted to SELECT THE VATS FOR MENU UPGRADE.
5. When the update has completed on ALL screens, press the YES button to confirm.
6. Ensure the USB is removed from the fryer.
7. To power cycle the system, push and hold the black toggle switch from step 2 for
8. Repeat steps 1-7 for additional menus. If complete, advance to next step.
9. Slide the USB cover down to cover the port.
Step 9 - Verify the software update on all displays.
1. On ALL the screens, press
2. When the versions are displayed, confirm they all match the new software versions.
3. If software versions match on ALL screens, press
4. If software versions DO NOT match, press
Step 10 – Reposition the Filter Pan
Push the filter pan back into the fryer
Step 11 – Verify Menu Update and Product location
1. Power on all controllers.
2. Wait for all vats to heat to setpoint and all product images are displayed.
3. Press the menu button to advance from ALL RECIPES to BREAKFAST to LUNCH to CHANGEOVER.
4. Ensure products and images are in each menu.
5. If any current products or LTO (Limited Time Offers) are missing from menus, the products will need assigned to a
location. Some products may need reprogrammed into each controller, as they may have been overwritten during the
update.
6. Follow the instructions below to change product location assignment.
60 SECONDS
1656
SERVICE MANAGER
SOFTWARE VERSION
and proceed to Step 10.
and repeat Step 6 - Update the Software.
until a "P" is NOT visible on the top right corner of the display.
Page 42 of 44
to power cycle the system
.
USB - MENU OPERATION
COPY MENU FROM USB TO FRYER
60 SECONDS.