Table of Contents
Advertisement
This chapter describes how to connect the CTP100T adapter to your
network. Ensure that all the requirements and specifications outlined in
Chapter 2 and Appendix A are met before installing the CTP100T
adapter.
3.1 Unpacking
Before installing the CTP100T adapter, unpack and check the contents
of the shipping box as follows:
1.
Carefully remove the CTP100T adapter, a 12 Vdc 800 mA power
supply, and a plastic accessory bag from the shipping box. Save
the packing materials in case the unit needs to be reshipped.
2.
Remove the CTP100T adapter from the packing material and its
protective plastic bag. Set the unit aside to prevent it from being
damaged.
3.
Remove the 12 Vdc, 800 mA power supply from its box. Set the
unit aside to prevent it from being damaged.
4.
Check the plastic accessory bag for the following items:
•
One set of Velcro mounts
•
Two 6-inch tie wraps
•
Two cable mounts for strain relief
Contact Cabletron Systems Technical Support immediately if any dis-
crepancies exist.
CTP100T USER'S MANUAL
CHAPTER 3
INSTALLATION
Page 3-1
Advertisement
Table of Contents
