Surface Mounting The Ctp100T Adapter - Cabletron Systems CTP100T User Manual

CHAPTER 3: INSTALLATION
3.2 Installation
If the CTP100T adapter is going to be mounted on a flat surface, pro-
ceed to Section 3.2.1. Otherwise, proceed to Section 3.2.2 to install the
CTP100T adapter.

3.2.1 Surface Mounting the CTP100T Adapter

Using the contents of the accessory package, you can surface mount the
CTP100T adapter. The surface you choose should meet the following
requirements:
• Allows easy access to connect the twisted pair segment to the
adapter.
• Allows easy access to connect the coaxial segment to the adapter.
• Is within 6 feet of an appropriate power source such as a USA
standard (NEMA) 3-prong outlet. The power source needed is
dependent on the power supply shipped with the CTP100T
adapter.
• Has a smooth, clean surface that accepts the adhesive bonding of
the Velcro mount.
Mount the CTP100T adapter as follows:
1. Separate the two-part 1.5-inch by 3-inch Velcro mount.
2. Peel off the paper that covers the adhesive backing of one part of
the mount.
3. Carefully position the Velcro on the back of the CTP100T adapter.
Be sure to press firmly so that the adhesive firmly affixes to the
unit.
4. Similarly, place the other half of Velcro on the surface on which you
want to mount the CTP100T adapter.
Page 3-2 CTP100T USER'S MANUAL