Application - Cabletron Systems CTP100T User Manual

CHAPTER 1: INTRODUCTION
LED
PWR Power – On when the transceiver is receiving power
(green) from the external wall transformer.

1.3.6 Application

The CTP100T adapter can be used with any of Cabletron Systems
10BASE-T compliant products, such as the MMAC Twisted Pair Media
Interface Modules (TPMIM 22/24/32/34), the MRXI, and the MiniMMAC.
For information on these products, refer to the appropriate installation
guides.
The CTP100T adapter may be used to connect a thin-net segment with
up to 10 nodes to a 10BASE-T segment.
For example, a TPMIM 22/24/32/34, MRXI, or a MiniMMAC could be
connected to an existing unused twisted pair cable. The cable could be
part of the building distribution wiring running into a distribution closet
and connected either directly or through a punchdown block to a
Cabletron Systems hub.
Referring to Figure 1-2, assume that in this configuration a 10BASE-T
twisted pair network is set up using the existing twisted pair cable
eliminate the cost of pulling cables. The CTP100T adapter
make the connection between the twisted pair cable and a thin-net
coaxial segment
adapter, the twisted pair cable is connected to the RJ45 port and the
thin-net coaxial cable segment is connected to the BNC port.
Page 1-6
Table 1-1. LANVIEW LEDs (Continued)
, which can have up to 10 nodes
DESCRIPTION
CTP100T USER'S MANUAL
is used to
. At the CTP100T
to