Table of Contents
Advertisement
This chapter contains instructions for preparing and installing
your Cabletron Systems FDDI network adapter into your
computer. The next chapter, Network Connections, provides
instructions for connecting the adapters to an FDDI network.
2.1
HARDWARE REQUIREMENTS
The F30XX family of FDDI network adapters is designed for any
computer that supports IBM 32-bit Micro Channel (MCA) Bus
architecture. The F70XX family of FDDI network adapters is
designed for any computer that supports the Extended Industry
Standard (EISA) Bus Architecture.
Installation of the Cabletron FDDI network adapters is simple and
straightforward. The network adapters are software configurable;
they have no jumpers or switches.
2.2
UNPACKING THE ADAPTERS
The FDDI network adapter and software are shipped separately.
The hardware package should contain one box with an FDDI
network adapter and this manual. The shrink-wrapped software
package contains a Network Software Installation Guide, the
software diskette, and the license agreement.
To unpack the adapter and the software, carefully remove the
adapter from the box. Leave the adapter in the conductive pouch
until you are ready to install it. Open the shrink-wrapped package
when you are ready to install the software. Be sure to read the
licensing agreement included in the shrink-wrapped package.
Contact Cabletron Systems Technical Support immediately if any
discrepancy in materials exists.
CHAPTER 2
INSTALLING THE ADAPTERS
INSTALLING THE ADAPTERS
Page 2 - 1
Advertisement
Table of Contents
