Enable Vacationmode; Disable Vacationmode; Factory Reset The Keypad - Ghost Controls AXWK Manual

ENABLE VACATION MODE:
Denied access to property until taken off this mode)
When Vacation Mode is enabled the gate will stay closed and all RF remote devices that control the gate will not be able to
open the gate. The gate opener will BEEP TWICE if attempting to open the gate while Vacation Mode is enabled.
A. Press and Release VACATION BUTTON
B. Enter your Primary Pin
C. Press SEND
DISABLE VACATION MODE:
When Vacation Mode is disabled the gate opener will BEEP THREE (3) TIMES to indicate Vacation Mode is disabled.
A. Press and Release VACATION BUTTON
B. Enter your Primary Pin
C. Press SEND
NOTE: IF THE ABOVE DOES NOT DISABLE VACATION MODE TURN THE GATE OPENER OFF AT CONTROL BOX AND
THEN BACK ON AND THIS WILL EXIT VACATION MODE.

FACTORY RESET THE KEYPAD:

■ Remove one of the C Batteries from the keypad and then press any button on the keypad.
■ Reinsert the battery, wait for the keypad to beep 3 times.
■ Immediately press and release the PROGRAM BUTTON 3 times.
■ The keypad will perform 3 long beeps followed by 2 short beeps to indicate successful factory reset.
■ MUST perform "PROGRAMMING THE KEYPAD FOR THE 1ST TIME" again.
8
© G h o s t C o n t r o l s 2 0 2 1
(This keeps your gate closed and all remotes or codes to keypad are
THE GATE MUST BE FULLY CLOSED BEFORE PUTTING IN THIS MODE.
(Do this only when Primary Pin has been forgotten)