Enable/Disable Partymode Secure Or 1-Key Mode; Enable/Disable Vacationmode; Factory Reset The Keypad - Ghost Controls AXWK Manual

ENABLE/DISABLE PARTYMODE SECURE OR 1-KEY MODE:

the keypad allows guest to enter your property while keeping it secure because the gate shuts after each guest when
autoclose is set)
PartyMode Secure or 1-Key Enable:
useful when guest is not require to use PIN to operate the gate such as when it is installed on the inside of the property for exit.
We recommend that the Autoclose feature on the gate opener is enabled when using this feature.
A. Press and Release 1-KEY BUTTON
B. Enter your Primary Pin
C. Press SEND
Repeat the above steps to disable this Mode.
ENABLE/DISABLE VACATION MODE:
keypad are Denied access to property until taken off this mode)
The gate will stay closed and all RF remote devices that control the gate will not be able to open the gate.
Vacation Mode Enable:
The gate opener will BEEP TWICE if attempting to open the gate while Vacation Mode is enabled.
NOTE: IF THE ABOVE DOES NOT DISABLE VACATION MODE TURN THE GATE OPENER OFF AT CONTROL BOX AND
THEN BACK ON AND THIS WILL EXIT VACATION MODE.
A. Press and Release VACATION BUTTON
B. Enter your Primary Pin
C. Press SEND
Repeat the above steps to disable VacationMode.
exiting Vacation Mode.

FACTORY RESET THE KEYPAD:

■ Remove one of the C Batteries from the keypad and then press any button on the keypad.
■ Reinsert the battery, wait for the keypad to beep 2 times.
■ Immediately press and release the PROGRAM BUTTON 3 times.
■ The keypad will perform 3 long beeps followed by 2 short beeps to indicate successful factory reset.
■ MUST perform "PROGRAMMING THE KEYPAD FOR THE 1ST TIME" again.
When enabled, the '1-Key' will be ON and any number key will operate the gate. This mode is
The gate opener will BEEP THREE (3) TIMES to indicate that it is
(Do this only when Primary Pin has been forgotten)
1
(This keeps your gate closed and all remotes or codes to
© G h o s t C o n t r o l s 2 0 2 0
(Pressing any # key on
7