Test Primary Pin; Mounting The Keypad - Ghost Controls AXWK Manual

C. TEST PRIMARY PIN: Test to verify gate opens. (Make sure DIP#2 on System control board is to the right so that you can
hear the WARNING from the gate opener system.)
1. Enter your 4 DIGIT PRIMARY PIN
2. Press SEND
Once the valid access PIN and SEND is entered, the keypad will stay active for 30 seconds. During this time, the keypad will
send a 'CYCLE' signal to the gate upon a press of any number key. Each 'CYCLE' signal will cause the gate to operate as follow:
...OPEN, STOP, CLOSE, STOP, OPEN, STOP...
After 30 seconds of inactivity, the keypad will beep twice and enter Standby Mode. This is its normal condition after 30
seconds of inactivity.
D. MOUNTING THE KEYPAD:
1. Keypad should be 60' or less from the gate.
2. Keypad should be at least 10' outside the
path of the moving gate.
3. Keypad must be in sight of the gate.
AXGN OUTDOOR MOUNTING PEDESTAL:
For Mounting Keypad to a wooden or metal post.
(not included)
© G h o s t C o n t r o l s 2 0 2 1
3