Cabletron Systems CSMIM-T1 Quick Start Manual page 15

% na
command: annex 192.9.200.62
command: port 6
command: set port speed 115200
command: set port control_lines modem_control
command: set port input_flow_control start/stop
command: set port output_flow_control start/stop
command: set port type dial_in
Inbound Modem
command: set port mode auto_detect
Outbound Modem
command: set port mode slave
Inbound/Outbound
command: set port mode auto_adapt
command: reset port 6
command: quit
Serial Printer
Serial printers can be connected to any Annex serial port. In this example
the printer is connected to port 12. Print instructions use the address L12.
Set the port parameters using na and send data to the printer using aprint:
% na
command: annex 192.9.200.62
command: port 12
command: set port speed 19200
command: set port type hardwired
command: set port mode slave
command: reset port 12
command: quit
% aprint -A 192.9.200.62 -L12 [filename]
Parallel Printer
The Annex parallel ports are configured for a Centronics interface, but can
be set for other standards (port 2 in the examples).
Centronics Interface
Send data to the printer using aprint:
% aprint -A 192.9.200.62 -p1 [filename]
Remote Annex Quick Start for Windows 7