Hardware Setup - Cabletron Systems CSMIM-T1 Quick Start Manual

The na and Quick2Config Annex software can be loaded on
Windows NT Workstations (3.51 or 4.0) and on Windows 95
platforms.
Quick2Config Annex can be installed on Windows for
Workgroups 3.11 and Windows 3.1 systems.
To install Quick2Config Annex on a Windows platform:
1 Put the CD-ROM into the Windows NT server's CD drive.
2 Use the File Manager to select the CD-ROM disk.
3 Double-click on the setup.exe file.
4 Follow the dialog box instructions to select Install Software and
then Quick2Config Annex.
5 When prompted for an installation directory, accept the default
directory for each software module.
Refer to Installing Remote Annex Network Software for Windows for
information about installing the na and Quick2Config Annex software on
Windows platforms.
the CD-ROM. See Installing Remote Annex Network Software
for Windows for details.

Hardware Setup

To set up the Remote Annex hardware:
1 Connect the power and connect the Remote Annex to the
network. If you are setting up a Remote Annex 6300, connect
CSU (DTE) to the Remote Annex and connect CSU (Net) to the
PRI Line.
2 Connect the console cable and terminal.
The Remote Annex 4000, 6100, and 6300 have a dedicated
console port.
Remote Annex Quick Start for Windows
If you are installing Quick2Config on a Windows 3.1 or
Windows for Workgroups 3.11 platform, you may be
required to install additional software that is provided on
3