V-fit AL16/1CE Assembly & User Manual page 21

7
Remove the 2 x M5 x 12mm Screws (76) from the back of the Exercise Monitor
(83). Connect the Exercise Monitor Link Wire (42) and the Pulse Sensor Wire (82)
to the Exercise Monitor (83), matching like for like and feeding any excess wire
back into the upright. Carefully fit the Exercise Monitor (83) onto the Exercise
Monitor Bracket and secure using 2 x M5 x 12mm Screws (76) that were removed.
8
Remove the 3 x M8 Nylon Nuts (37) and 3 x M8
Flat Washers (36) from underneath the Saddle
(93), then attach the Saddle (93) to the Saddle
Support (92) using the 3 x M8 Nylon Nuts (37)
and 3 x M8 Flat Washers (36) that were removed.
Fit the Saddle Stem Support (92) to the Saddle
Post (91) and secure using 1 x M8 Flat Washer
(36) and 1 x M8 Locking Knob (90). Insert the
Saddle Post (91) to the Main Frame (33) using
1 x M12 Adjustment Knob (95). Adjust the height
of Saddle Post (91) allowing for a slight bend in
the knee when the pedal is at its lowest position.
Note
FULLY TIGHTN all Bolts, Nuts and
Fittings now, ensuring that your
product in located on a clear flat
surface before doing so. Your
product will now be ready to use.
Assembly
SENSOR
PULSE
Page 21