Cabletron Systems Access Server 316 Hardware Owner's Manual page 61

Example
Local> SHOW MEMORY CONFIGURATION
Dynamic RAM:
Non-Volatile RAM:
Flash RAM:
Installed:
Total size:
Boot block:
Load image:
Name:
Size:
Version:
NOTE If Flash RAM is installed, but its boot block is invalid, then the total memory size
will be displayed as zero.
Your Flash RAM can also be updated with the INITIALIZE command. This
command copies the load image to Flash RAM. For more information about the
SHOW MEMORY CONFIGURATION or the INITIALIZE command, refer to the
Network Access Software Management guide or Network Access Software Commands
guide.
Replacing and Adding Flash RAM
4M bytes
32K bytes
Yes
4M bytes
Valid
WWENG2
967756 bytes
V2.3
6-9