Replacing And Adding Memory; Swapping Or Replacing An Access Server 316 Unit - Cabletron Systems Access Server 316 Hardware Owner's Manual

Replacing and Adding Memory

This chapter describes and illustrates the procedures for handling single-in-line
memory modules (SIMs) and Flash RAM when swapping out an Access Server
316 unit, and it shows how to replace a faulty SIM and add memory.
This chapter includes the following sections:

• Swapping or Replacing an Access Server 316 Unit

• Replacing a Faulty Single-In-Line Memory Module
• Additional Memory Supported
• Installing Extra Memory
Swapping or Replacing an Access Server 316 Unit
Whenever an Access Server 316 unit is replaced, the Single In-Line Memory
Modules (SIMs) and FLASH CARD must be REMOVED from the old unit and re-
installed in the replacement. The removable Flash Card is used for installation of
the Network Access Software and is not required for the operation of the unit.
Before an Access Server 316 is swapped, assure that at least one memory SIM is
installed. Please refer to the following chapters for the correct procedure for
removing and installing SIMs and Flash Cards.
SIMs are sensitive to static and are packed in anti-static packaging. Electrostatic
Discharge (ESD) can cause failure of electronic components and can reduce the
!
long term reliability of the Access Server 316. Cabletron recommends that you use
CAUTION
an anti-static kit or ESD wrist strap when handling SIMs.
Chapter 5
5-1