Contents In Package; Assembly And Adjustment - Genesis GTS10SC Operator's Manual

UnpaCKinG anD ConTenTS
iMporTanT:
faulty or that a part is missing. if you find anything wrong, do not operate the tool until
the parts have been replaced or the fault has been rectified. failure to do so could result
in serious personal injury.

CONTENTS IN PACKAGE

item Description
1. Table Saw Assembly
2. Miter Gauge
3. Rip Fence
4. Aluminum Guide
5. Blade Guard
6. Blade Control Wheel Handle 1
7. Push Stick
8. Blade Change Wrenches
9. Short Top Brackets (A)
4
7
9
10
11
12
13
14

aSSeMBLY anD aDJUSTMenT

WarninG:
failure to comply could result in accidental starting and serious personal injury.
WarninG:
table saw, plug in the power source, or turn the switch on until the missing or damaged
part is obtained and it installed properly.
WORK STAND ASSEMBLY
use screws, washers and nuts provided to attach the stand pieces. Do not tighten the screws completely until leg
stand is completely assembly. See FIG 3.
1. Attach the short top brackets (A) to the stand legs 13.
Due to modern mass production techniques, it is unlikely the tool is
(fiG 2)
QTY item Description
1
1
1
1
1
1
2
2
8
15 6
Do noT connect to power source until assembly is complete.
if any part is missing or damaged, do not attempt to assembly the
10. Long Top Brackets (B)
11. Short Support Brackets(C) 2
12. Long Support Brackets (D) 2
13. Stand Legs
14. Rubber Feet
15. Hardware Set
16. Allen wrench
17. Wrench
18. Operator's Manual (not shown)
2
5
16
QTY
2
4
4
1
1
1
fiG 2
17
1
3
9