Operation; Cutting Tips - Genesis GTS10SC Operator's Manual

operaTion

WarninG:
before clearing the table of all tools, wood scraps,
etc, except the work piece and related feed or
supporting devices.
ON/OFF SWITCH (FIG 19)
The saw is equipped with a ON/OFF switch (13).
1. To turn the saw ON, press the switch button "I".
2. To turn the saw OFF, press the switch button "O"
OVERLOAD RESET SWITCH (FIG 19)
WarninG:
if overload reset switch is pushed, the on/off
switch must be in the off position and plug should
be removed from the power source while cooling
down. overheating may be caused by dull blade or
misaligned parts. inspect your saw for proper setup
before using it again.
Your saw is equipped with an overload reset switch (11) that will
allow the motor to be restarted after it shuts off due to overloading
or low voltage. If motor stops during the operation, take the
following steps:
1. Press the switch button "O" to turn OFF the saw.
2. Wait about five minutes for the motor to cool down.
3. Push in the reset button.
4. Press the switch button "I" to turn ON the saw
SAWDUST COLLECTION (FIG 20, 21)
This table saw has a removable sawdust collector (18) below the
saw blade and a dust chute (19) on the blade guard. See FIG 20. A
dust collection system can be attached to either or both dust chutes
to help remove sawdust from the work area.
To remove the sawdust collector(18), simply loosen two butterfly
nuts (18a) and remove the collector from the saw. See FIG 21.
PUSH STICK AND PUSH BLOCK
A plastic push stick is supplied for rip cutting widths of 2" to 6".
use the auxiliary fence and push block for rip cutting widths narrower than 2". When ripping, apply the feed force
to the section of the work piece between the saw blade and the rip fence.
appLiCaTionS

CUTTING TIPS

1. Make sure the kerf is made on the scrap side of the measuring line.
2. Cut the wood with the finish side up.
3. Always have a proper support for the wood as it comes out of the blade.
4. Make a test cut for important cuts.
5. Always use the correct blade depth setting. The Top of the blade teeth should clear the work piece by 1/8"
(3mm) to 1/4" (6 mm).
6. Inspect the work piece for knots or nails before beginning a cut. Remove any loose knots or nails with a
hammer.
7. Always use clean, sharp, properly-set blades, Never make a cut with dull blade.
8. When making a cut, use steady, even pressure, Never force a cut.
14
Do noT turn on the table saw
To prevent accidental startup
10" Table Saw
Operator's Manual
11
13
19
18
18
18
fiG 21
GTS10SC
fiG 19
fiG 20
18a