Contents In Package - Genesis GMSS400W Operator's Manual

• Turn tool switch off and disconnect power before mounting to the stand.
• Never stand on the product. The total weight of the saw and the workpiece
must not exceed 400 lb.
• This stand will accommodate the miter saws with blade diameter of 12" or
less.
Never to be used with any miter saws with a blade diameter larger than 12".
• Only use the GMSS400W for the purpose described in this manual.
than those mentioned in this manual will be considered misuse. The manufacturer shall not be liable for any
damage or injury resulting form such cases of misuse.
KNOWING YOUR MITER SAW STAND
(Refer to FIG 1)
1. Saw Mounting Brackets
2. Extension Rail
3. Support Roller
4. Work Stop
5. Material Support Locking Knob
UNPACKING AND CONTENT
IMPORTANT
faulty or that a part is missing. If you find anything wrong, do not use the product until
the parts have been replaced or the fault has been rectified. Failure to do so could result
in serious personal injury.

CONTENTS IN PACKAGE

Item#:
A
B
C
D
E
F
G
H
I
J
ASSEMBLY
INSTALLING WHEELS & RUBBER FEET (See FIG 3)
To Install Wheels
1. Place the stand's top surface down on the floor with the folded legs on the top.
2. Remove the straight cotter pin (G2) from one end of the axle (G). Keep the bent cotter pin (G1) in place on the
other end.
3. Insert a wheel washer (E), a wheel (D), then a second wheel washer onto the axle (G) in order.
NOTE:
Make sure the concave side of the washer is facing the wheel.
4. Insert the axle & wheel assembly through the wheel holder (A5) on the stand.
5. Insert the third wheel washer, a wheel, and the fourth wheel washer onto the end of the axle.
6
SAVE THESE INSTRUCTIONS
:
Due to modern mass production techniques, it is unlikely the tool is
:
( Refer to FIG 2)
Description
Miter Saw Stand
Saw Mounting Brackets
Material Supports
Wheels
Wheel Washers
Rubber Feet Set
Axle for Wheels
Mounting Fasteners (M8 x 55mm )
Mounting Fasteners (M6 x 35 mm)
Operator's Manual (Not Shown)
Miter Saw Stand
Operator's Manual
6. Extension Rail Locking Knob
7. Material Support
8. Wheels
9. Adjustable Foot
QTY
1
2
2
2
4
2
1
4
4
1
GMSS400W
Any use other