Blaupunkt Q Series Installation And Operation Manual page 21

4.8.2 Away Arm and Home Arm Settings
• Entry Delay Time / Entry Delay Time 2: When a sensor set to Entry 1 or Entry 2 is triggered under Away Arm
or Home Arm mode, the panel will begin an entry countdown according to the length set with this function.
The Entry 1 attribute corresponds to Entry Delay Time length and Entry 2 attribute corresponds to Entry Delay
Time 2 length.
• Entry Delay Sound: Set the Entry Delay countdown volume.
• Exit Delay Time: When the panel changes to Away Arm or Home Arm mode, it will begin counting down an
Exit Delay time according to the set time length. When the time expires, the panel will enter the arm mode that
was set. All home occupants must leave the area covered with activated sensors before the Exit Delay Time
expires or an alarm is triggered.
• Exit Delay Sound: Set the Exit Delay countdown volume.
4.8.3 Temperature Settings (Temperature Sensor required)
• High Temperature: When the temperature rises above a set value, the Control Panel will send a report to the
server to notify the High Temperature condition. If the temperature drops back under the set value again, the
Control Panel will send a High Temperature Restore report.
• Low Temperature: When temperature drops below a set value, the Control Panel will send a report to the
server to notify the Low Temperature condition. If the temperature rises above the set value again, the Control
Panel will send a Low Temperature Restore report.
21