Table of Contents
Advertisement
Storing and Restoring Setup Menus
6-64
Chapter 6 Setup
You can store and restore the data of the setup menus listed below,
either by storing/ restoring the data for all of the menus at once or
by storing/restoring the data for individual menus.
SETUP DATA
BKE-701 SETUP
INIT DATA
AUX DATA
To store setup menus
Proceed as follows.
1
Press the SETUP (SHIFT + DISS) button to put the system
into setup mode.
2
To store an individual menu, navigate to that menu. To store
all of the menus, stay on the current level and proceed to step
3.
3
Press the CTRL + F/TC buttons to specify the storage block.
The current storage block appears in the scratchpad.
Example: STORE BLOCK USR1
4
Press the ALL STOP button to switch between the four
storage blocks as required.
Switching order: STORE BLOCK USR1 > STORE BLOCK
USR2 > STORE BLOCK USR3 > STORE BLOCK USR4
5
Press the ENTER key when the desired storage block appears
in the scratchpad.
The current setup menu data is stored to the specified block.
Note
If the mode that uses BLOCK USR1 at system boot time has been
specified, the message "USR1OWRITE OK?" appears in the
scratchpad. This message is intended to protect the data in the
block. If you want to store data to the block anyway, press the
CTRL + ENTER button.
Advertisement
Table of Contents
