Paper Misfeed Detection Conditions - Olivetti PG L2555 Service Manual

(2) Paper misfeed detection conditions

Problem
(1)
Paper will not feed
properly into printer.
(2)
Bulk paper feeder
does not raise/lower
tray.
Causes/check procedures
Too much paper in bulk
paper feeder.
Paper too slick or stack
together tightly.
Paper is damaged.
Side plates inside the bulk
paper feeder are improperly
set.
Tray cover not closed/
opened.
Printer not powered on.
Bulk paper feeder not prop-
erly mounted on the printer
base (rail).
Bulk paper feeder's con-
nector not properly con-
nected to the printer's
connector.
Corrective measures
Open tray cover. Remove any quantity in excess of the marked
limit.
Fan and flex paper to separate sheets. Check that paper isn't too
shiny or slick causing rollers to slip. Replace with plain paper to
check bulk paper feeder operation. Refer to paper specifications
section later in this manual for proper paper. Clean rollers of bulk
paper feeder with lint-free cloth.
Check paper stack for bent corners, edges.
Set the side plates so that a 1-mm gap is left between each side of
the paper stack and the side plate.
Open/close tray cover.
Plug printer power cord.
Mount bulk paper feeder aligning the arrow marks on the bulk
paper feeder with the arrow marks on the rail.
Press the bulk paper feeder toward the printer firmly to ensure
good contact of both connectors.
1-3-2