Taillamps, Turn Signal, Sidemarker,
Stoplamps and Back-up Lamps
A. Turn Signal/Taillamp
B. Stoplamp/Taillamp
C. Back-up Lamp
D. Sidemarker Lamp
To replace one of these bulbs, do the following:
2. Remove the taillamp assembly.
3. Press the release tab and turn the bulb socket
counterclockwise to remove it from the taillamp
assembly. The sidemarker lamp does not have a
release tab.
4. Pull the bulb straight out from the socket.
5. Install a new bulb into the socket and insert it into
the taillamp assembly
6. Turn the bulb socket clockwise until it clicks. The
sidemarker lamp does not have a release tab and
therefore will not click when it is installed.
7. Reinstall the taillamp assembly and tighten the
screws.
1. Remove the
two screws from the
taillamp assembly.
5-55