Removing The Bench Seat - Cadillac 2006 Escalade Owner's Manual

6. Pull up on the release lever labeled 1, located on
the rear of the seatback, and then pull up on the
seatback until it locks into the upright position.
CAUTION:
{
If the seatback is not locked, it could move
forward in a sudden stop or crash. That could
cause injury to the person sitting there. Always
push and pull on the seatback to be sure it is
locked.
7. Push and pull on the seatback to make sure it is
locked.

Removing the Bench Seat

To remove the seat, do the following:
1. Open the liftgate to access the controls for the
bench seat and enter the rear of the vehicle.
2. Fold the seatback forward using the instructions
listed under "Folding the Seatback" previously.
The seat cannot be removed unless the seatback
is folded.
1-22
4. Lift the rear of the seat up from the floor.
6. While holding the rear of the seat up, roll the seat
out of the vehicle.
3. Pull up on the release
lever labeled 2, located
at the rear of the
seat, to unlatch the
rear of the seat
from the floor.
5. Pull on the release
strap, located in the
lower center of
the seat, to release the
seat from the floor
and pull the seat out.
Use one hand to
pull the release strap
and the other on
the handle to pull the
seat out.