Table of Contents
Advertisement
Quick Links
STELLAR BLACK
DELUXE PATIO HEATER
Model No. PH7056 / PH7057
The ideal solution for extending the outdoor
entertaining season
Direct ignition
Maximum output 40MJ/h
Adjustable heat output
Includes wheels
Operates for approximately 9 hours on a properly
filled 9Kg propane cylinder
Includes a safety 'tip-over' switch that halts supply of
gas to the unit should it be accidentally knocked over
Flame safeguard system for enhanced safety
Complete with hose and regulator
For outdoor use only
Gas certified to Australian standards
FOR YOUR SAFETY
If you smell gas:
1. Shut off the gas to the appliance.
2. Extinguish any open flame.
3. If odour continues, immediately call your gas supplier.
Do not store or use gasoline or other flammable vapour
and liquids in the vicinity of this or any other appliance.
WARNING
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage.
Read the instructions thoroughly before installing or
servicing this equipment.
FOR OUTDOOR USE ONLY
PROPANE GAS
Important: Retain these instructions for future use.
03908 04/19
Advertisement
Table of Contents
Related Manuals for Gasmate PH7057
Summary of Contents for Gasmate PH7057
- Page 1 STELLAR BLACK DELUXE PATIO HEATER Model No. PH7056 / PH7057 The ideal solution for extending the outdoor entertaining season Direct ignition Maximum output 40MJ/h Adjustable heat output Includes wheels Operates for approximately 9 hours on a properly filled 9Kg propane cylinder Includes a safety ‘tip-over’...
-
Page 2: Installation
Installation, Operation and Maintenance Instructions INSTALLATION Proper clearance from combustible materials must be maintained at all times. The minimum clearances are as follows: Important Safety Rules Minimum Clearance from Combustibles: This appliance must only be used in a well ventilated Side 500 mm Rear... - Page 3 (1) DO NOT bypass thermocouple safety; PH7056 Colour Black (2) DO NOT operate heater without the reflector; PH7057 Colour Graphite Clothing or other flammable materials should not be hung Heater specifications can be found on the data label. from the heater, or placed on or near the heater. The area above the burner may be extremely hot.
- Page 4 PATIO HEATER - For Outdoor Use Only Minimum Clearance from Combustible Surfaces*: 860mm Burner head assembly Cylinder cover 460mm *Combustible materials are considered to be wood, compressed paper, plant fibres, plastic or other materials that are capable of being ignited and burned.
-
Page 5: Reflector Assembly
REFLECTOR ASSEMBLY STEP 1 Place the 3 parts of reflector segments to overlap together and attach with 3 screws, washers and nuts. STEP 2 Place round part of reflector over the 3 segments and attach with 6 screws, washers and nuts. -
Page 6: Tools Required
PATIO HEATER ASSEMBLY Nuts Washers Tools Required Phillips head screwdriver 2 Adjustable spanners Note: Remove any transit protection material STEP 1 Secure the post onto the post support with 6 screws, feed the hose up through the post and temporarily secure the end with tape to the post Washers top. -
Page 7: Troubleshooting
TEST FIRING HEATER Test fire heater, following the lighting instructions on heater post. Leak test all gas connections with soapy water. Soap bubbles indicate gas leakage. DO NOT use a match to test for gas leaks. WARNING: White smoke may appear around the radiant head during the first minute of the initial firing. TROUBLE SHOOTING Problem Possible Causes... - Page 8 SAFE APPLIANCE LOCATIONS This appliance shall only be used in an above ground open-air situation with natural ventilation, without stagnant areas, where gas leakage and products of combustion are rapidly dispersed by wind and natural convection. Any enclosure in which the appliance is used shall comply with the following: An enclosure with walls on all sides, but at least one permanent opening at ground level and no overhead cover (see Example 1).