Table of Contents
Advertisement
Intended Use
- Do not operate the unit near heat sources such as
radiators, open fire or sparks.
- Do not inhale health-endangering vapours! (Ob-
serve the safety data sheets of the cleaning agent
manufacturer).
- Fill the cleaning agent up to the specified level of
the parts tray.
- Keep children and persons not familiar with the part
washing unit away from their working environment.
- The part washing unit must not be used by persons
with reduced physical, sensory or mental perfor-
mance.
- Never work under the influence of concentration ill-
nesses, fatigue, drugs, alcohol or medication.
- Only use the part washing unit in well-ventilated
rooms.
- Check the device for damage. Damaged parts
should be properly repaired or replaced.
- Only use original spare parts and accessories to
avoid possible hazards and risks of accidents.
ATTENTION!
- Do not pull the cable. Only pull on the plug to dis-
connect it. Keep the cable away from heat sources,
oil and sharp edges.
- Always ensure that the device is switched off at the
ON/OFF switch before inserting the power plug into
the socket.
ATTENTION!
The part washing unit may only be operated with
non-flammable liquids and only with water-based
cleaning agents!
3
Intended Use
The part washing unit is designed exclusively for thoro-
ugh cleaning of workpieces with water-based cleaning
solution. The part washing unit is only approved for ope-
ration with suitable cleaning agents and may only be
operated by persons who have been instructed in the
use of the device.
Proper use also includes compliance with all information
in this manual. Any use beyond the intended use or
otherwise is considered misuse.
For structural and technical changes to the part washing
unit, the company Stürmer Maschinen GmbH assumes
no liability.
Claims of any kind due to damage due to improper use are
excluded.
6
4
Technical Data
Model
TWG 20
Length
430 mm
Width / Depth
340 mm
Height
220 mm
Weight
6,5 kg
Supply voltage
230 V/
~50 Hz
Cabine
20 l
capacity
Max. weight on
10 kg
support grille
Speed of
3,3 l/min
circulation
Minimum sol-
10,5 l
vent capacity
Connection
1,5 m
cable length
Absorbed po-
0,026 kW
wer drive motor
4.1 Type plate
Fig. 2: Type plate
TWG 80
TWG 150
760 mm
1090 mm
540 mm
540 mm
880 mm
890 mm
23 kg
42 kg
230 V/
230 V/
~50 Hz
~50 Hz
80 l
150 l
20 kg
40 kg
3,3 l/min
3,3 l/min
36 l
72 l
1,5 m
1,5 m
0,026 kW
0,026 kW
TWG-Series | Version 1.01
Advertisement
Table of Contents
