Commissioning - unicraft TWG 20 Operating Instructions Manual

Part washing unit
Table of Contents

Advertisement

Commissioning

- The blue coloured wire must be connected to the ter-
minal marked N or black.
- The brown wire must be connected to the terminal
marked L or red.
- The yellow-green coloured wire must be connected
to the terminal marked E or green.
Earth
(Yellow-green)
Neutral
(Blue)
Fig. 10: Electrical connection
WARNING!
Danger to live!
We strongly recommend that this device is
connected to the mains via an residual current ope-
rated device (RCD).
If in doubt, consult a qualified electrician.
8
Commissioning
ATTENTION!
The part washing unit may only be operated with
non-flammable liquids and only with water-based
cleaning agents!
WARNING!
Danger to life!
There is danger to your life if you do not follow these
rules.
- Never work on the part washing unit if you are under
the influence of alcohol, drugs or medicines and / or
you are overtired or suffer from concentration-impai-
ring illnesses.
- The part washing unit may only be operated by one
person. Other persons must keep away from the
work area during operation.
NOTE!
Before using the parts washer for the first time, carry
out the following points:
- Please check all screw connections on the as-
sembled the part washing unit and tighten them if
necessary.
- Check the part washing unit for leaks.
10
Always use a
13 amp fuse.
Live
(Brown)
Step 1: Connect the unit to the mains power supply and
Fig. 11: Switch on the part washing unit
Step 2: Place the parts to be cleaned in the part was-
Step 3: The parts should be completely covered by the
Step 4: Allow excess detergent to drain off, remove the
Step 5: At the end of the operation, switch off the pump
Use protective goggles!
Wear respiratory protection!
Wear safety boots!
Wear protective clothes!
Use protective gloves!
switch the unit to "ON" at the power switch
(Fig. 10).
hing unit.
cleaning solution. Depending on the degree of
contamination, allow the cleaning solution to
soak in for some time and then remove the
grease and dirt residues with a brush.
parts from the part washing unit and washing-up
them with warm water.
(position OFF), close the cover and remove the
plug from the socket.
TWG-Series | Version 1.01

Advertisement

Table of Contents
loading

Related Products for unicraft TWG 20

This manual is also suitable for:

Twg 80Twg 150622002062200806220150

Table of Contents