Table of Contents
Advertisement
Disposal, Recycling of used devices
9.3 Troubleshooting
ATTENTION!
If any of the following errors occur, immediately stop
working with the part washing unit. It can cause
serious injury or damage to the tool. All repairs or
replacement work must only be carried out by quali-
fied and trained personnel.
Fault
The cleaning agent does not flow
evenly.
After cleaning the pump inlet, the
pump performance stay insufficient.
10 Disposal, Recycling of used devices
In your own interests an in the interests of the eviron-
ment, please ensure that all components of the equip-
ment are disposed of in the proper and authorized way.
10.1 Decommission
Disused devices must be taken out of service immedi-
ately in order to avoid later misuse and endangering the
environment or people.
Step 1:
Remove all environmentally hazardous fluids
from the the part washing unit.
Step 2:
If necessary, disassemble the the part was-
hing unit into manageable and usable as-
semblies and components.
Step 3:
The product components and operating mate-
rials must be routed through the appropriate
disposal routes.
12
Possible cause
The pump may not be completely
covered with cleaning solution.
Line is contaminated.
10.2 Disposal via municipal collection points
Disposal of used electrical and electronic equipment
(Applicable in the countries of the European Union and
other European countries with a separate collection sy-
stem for this equipment).
ping to dispose of this product correctly, you will help
protect the environment and the health of those around
you. Environment and health are endangered by incor-
rect disposal. Material recycling helps to reduce the
consumption of raw materials. For more information
about recycling this product, contact your local autho-
rity, municipal waste disposal service or the shop where
you purchased the product.
10.3 Disposal of lubricants
Remove any excess, leaking or used grease from the lu-
bricated lubrication points.
The disposal instructions for the used lubricants are pro-
vided by the lubricant manufacturer. If necessary, ask
for the product-specific data sheets.
Solution
The pump must be completely
covered with cleaning solution for
proper operation (Fig. 6).
Unplug the power cord and clean
the line.
The symbol on the product or its packaging in-
dicates that this product should not be treated
as normal household waste, but should be
handed in at a collection point for the recycling
of electrical and electronic equipment. By hel-
TWG-Series | Version 1.01
Advertisement
Table of Contents
