Page 5
Use bolt (E) to secure the corner legs (9) and center leg (10) to the bottom panel (8). Screw cam bolt (C) into top panel.
Page 6
Insert dowels (A) into panels (2,3,4,5,6). Screw cam bolts (C) into panels (2,3,4) Attach side panel (3) to the angled edge of panel (5). Insert cam locks (D) into panel (5) and tighten with a screwdriver.
Page 7
Attach panel (2) to panel (5). Ensure the groove on panel (2) is toward the back. Insert cam locks (D) into panel (5) and tighten with a screwdriver. Attach the straight edge of panel (6) to panel (2). Insert cam locks (D) into panel (6) and tighten with a screwdriver.
Page 8
Attach side panel (4) to the angled edge of panel (6). Insert cam locks (D) into panel (6) and tighten with a screwdriver. Use wrench (H), screw (B) to secure the bottom panel (8) into panels (2,3,4).
Page 9
Slide back panels (7) into grooves. Place top panel (1) into panel (2,3,4). Inserts cam locks into panels (2,3,4) and tighten with a screwdriver.
Page 10
Secure both back panels (7) on all four sides using the plastic wedge (F) and screw (G). Place sticker (K) over holes as per diagram.