Airfilter; Spark Plug; Maintenance Of Bar And Chain; Maintenance Intervals - Texas A/S XCS4500 User Manual

Airfilter

For proper performance and durability, the air filter
should be kept clean of sawdust and debris.
1. Loosen and remove the top cover.
2. Remove the air filter out and tap it gently against a
hard surface in order to get the dust out. If the filter
is very dirty, the air filter can be separated in two
parts. Brush both parts with a soft brush.
3. Refit filter and top cover. Pay attention to that the
filter and cover is tightly fitted.
Clean the air filter every 5 hours, more often when
working in dusty areas.

Spark Plug

The spark plug is located inside the air filter.
The spark plug must be kept clean to function optimally
1. Check the spark plug as follows.
2. Turn the machines ignition switch to "stop".
3. Remove the spark plug spark plug.
4. Brush the dirt and sawdust from around the spark
plug.
5. Remove it with a spark plug wrench.
6. Check, clean or replace if necessary.
7. Install the spark plug safely and place the spark
plug cap on the spark plug.
Part number of new spark plugs: 429581

Maintenance of bar and chain

Lubrication hole. Dismount bar and control on
Bolthole is blocked with sawdust or dirt. Lubricate with
oil / grease.
Swords. Clean the nose wheel and running path for
dirt. Turn any sword to distribute the wear. A worn bar
can be dangerous to use and should be replaced.
Chain. Chain should be filed regularly for best results.
1. Make sure the bar is tightened properly.
2. Use a file.
3. File all the teeth with 3-4 coats, so they are
equal.
4. It is necessary to regularly inspect the height
of the teeth if they are too high, they should be
filed with a flat file.

Maintenance intervals

Part Action
Check /
Screws / Bolts
Tighten
Clean /
Air Filter
Replace
Fuel filter Replace
Sword / Drive
Clean
wheel
Clean / Adjust
Spark Plug
/ Replace
Fuelhose Check
Chain Brake Check
After
Each Use
Every 10. hours
Every 20. hours
Every Need
Every 20. hours
Every 20. hours
Each Use
15

Storage

1. Drain all fuel from tank into a container approved
for gasoline.
2. Start the machine and let it run until all fuel is
used.
3. Allow machine to cool
4. Remove the spark plug
5. Pour 1 teaspoon of 2-cycle oil into the spark plug
hole.
6. Pull slow in recoilline 2-3 times, this distribute
the oil in the engine.
7. Remove the spark plug safely and set spark plug
cap firmly.
8. Store the engine in a dry place
9. Comply with all relevant safety instructions due
to safe storage and handling of gasoline.

Technical specifications

Model
Cylinder
displacement
Net power
Fuel
Tank (fuel)
Tank (chainoli)
Chain Lubrecation
Anti-vibration
Weight
Bar
Bar type
Chain type
LWA Guarenteed
XCS4500
45 cc
-1
1.7 kW (12000/min .)
Oil mixed 40:1 (2,5%):
Unleaded Oktan 98/100 and
2-stroke oil
620 ml
250 ml
Automatic
Yes
6.7 kg
45 cm / 18"
Art. no. 403472
Art. no. 40-213
112 dB(A)