Bios Settings - Contec BX-M1000 Series Manual

BX-M1000 Pre-installed Model OS Manual(Windows 10 IoT Enterprise 2019 LTSC)

3. BIOS settings

After restarting the system by the method outlined above, immediately press [DEL] or [ESC] to start
the BIOS settings screen (Aptio Setup Utility).
Aptio Setup Utility - Copyright © 2018 American Megat
Advanced
RAS Configuration
Firmware Version
System Uptime
System AC Power-on Time
WDT during POST
WDT during Boot of the Time
PI2 Function
Win10 2019 Boot WDT
Aptio Setup Utility - Copyright © 2018 American Megatrends, Inc.
Main Advanced Chipset Security
Boot Configration
Setup Prompt Timeout 1
Bootup NumLock State [On]
Quiet Boot [Disabled]
Boot Option Priorities
Boot Option #1 [Windows Boot Manager
(P0: XXXXXXXXXXXXXXX)]
Boot Option #2 [UEFI: Built -in EFI]
Fast Boot [Disabled]
New Boot Option Policy [Default]
(Notice)
For non-software RAID configuration
x in the [Windows Boot Manager(XXXXXXX)] indicates the name of HDD/SSD connected.
For software RAID(RAID1) configuration
x in the [Windows Boot Manager(XXXXXXX)] indicates RAID configuration information of HDD/SSD
connected.
Aptio Setup Utility - Copyright © 2018 American Megatrends, Inc.
Main Advanced Chipset Security
Boot Configration
Setup Prompt Timeout 1
Bootup NumLock State [On]
Quiet Boot [Disabled]
Save & Exit Setup
Save configration and exit?
Yes No
—
Recovery Method
XX.XX
XXD XXH XXM XXS
XXD XXH XXM XXS
[Disabled]
[Disabled]
Win10 Boot WDT
Disabled
Enabled
Boot Save & Exit
Sets the system boot order
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-:Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
Boot Save & Exit
Sets the system boot order
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-:Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
— 52 —
—
1. Press the [→] key to select the "Advanced"
menu. Press the [↓] key to select the "RAS
Configuration" submenu.
Select [Enabled] from "Win10 2019 Boot WDT".
Press the [Esc] key to return to the Advanced
menu.
2. Press [→] key, select [Boot] menu.
Please check if the "Boot Option #1"
in Boot Option Priorities is assigned to
[Windows Boot Manager (P0:
XXXXXXXXXXXXXX)].
If not, assign it appropriately.
3. Press [F4] key, select [Save & Exit Setup].
Please [ENTER] key
If you save configuration.
The system will automatically reboot.